How To Reset Ring Floodlight Camera?

How do I manually reset my Ring camera?

To factory reset your Ring Camera: Locate the orange reset button on the back side of the camera. Press and hold the reset button for 15 seconds. After releasing it, the status light located on the back will flash a few times indicating the camera is restarting.

How do you reset a Ring light?

Using a power switch, turn the bulb off. Turn the bulb on and off six times. Each on cycle should last two seconds and each off cycle should last two seconds – for a total of four seconds. Wait about 30 seconds. At this point, your Ring should now be back to factory settings.

Why is my Ring floodlight motion light not working?

Check your batteries. Check the area around the Motion Sensor. There may be something in the area (like a small animal) that is triggering your sensor. Check your motion sensitivity controls in the Ring app.

How do I reset my front Ring camera?

Is there a way to factory reset a Ring?

Can you factory reset a Ring device?

Press and hold the setup button (located inside the device) with the battery in, until the LED stops flashing (approximately 10 seconds). Press and hold the Connect Button (located on the side of the device) for 10 seconds until the LED Ring blinks once, then release the button.

How do I reconnect my ring floodlight camera?

Tap on the Menu on the top left (≡) Tap Devices. Select the doorbell or security camera you need to reconnect to wifi. The next screen is the Device Dashboard. Tap Device Health. Tap on Reconnect to Wifi or Change Wifi Network.

How do you troubleshoot a ring light?

Check your batteries. Check the area around the lights. There may be something in the area (like a small animal) that is triggering your lights. Check your motion sensitivity controls in the Ring app. You may have them set too high for your layout.

How do I reset my CCTV camera?

How do I reset my Floodlight?

Performing a hard reset Hold down the top button for a full 30 seconds.